How to Control High Tunnel Lights Remotely via Wifi

How to Control High Tunnel Lights Remotely via Wifi

Since I installed the solar panel to get power out to the high tunnel, I have wanted to get insight into how much power the lights were drawing and to control them from the house if I needed to "burn off" some extra electricity so there would be room on the batteries for a sunny tomorrow.

First to note is that I have wifi out to my high tunnel. The signal is weak so I used an wifi extender. After doing some research I found out that the extended wifi network has to have the same SSID and Password as my main wifi network has.

 

 

Regresar al blog

Deja un comentario

Ten en cuenta que los comentarios deben aprobarse antes de que se publiquen.